Micropurge Sample Pro 19mm Portable Pump

Micropurge Sample Pro 19mm Portable Pump

Sampling Pump for 3/4 Inch Wells. The first fully take-apart sampling pump for direct push & small diameter wells.

Add to Request

The all-new 3/4″ Sample Pro Portable Pump is the first practical solution for collecting precise, accurate ground water samples from small diameter wells.Rugged, reliable, complete system designed for easy use in the field. Quick 1/4 turn disassembly with no tools means simple, fast and complete field cleaning. Disposable bladders and push-in tubing replace in seconds, speeding you on to the next well.
The pump uses the latest MicroPurge control components, including the lightweight MP15 Backpack Controller with its own compressed gas supply-no heavy generator needed!

Solid stainless steel construction is truly durable, with no motors, bearings, or impellers to go bad. Even if the pump fills with silt, it can be put into action again with aquick, simple cleaning. Output pressure is strong and controllable.

Save $$$ on sampling
Direct push technology and low flow sampling reduce the costs of well installation, sampling and purge water handling. This is the only sampling pump that minimizes turbidity and silting caused by the well surging of other devices such as bailers and jerk samplers, and collects quality samples from small diameter wells at significant savings.

Control Turbidity for Better Samples
No bailer churning, high volume purging, or high flow over-pumping to increase turbidity
Less turbidity means more consistent samples and fewer false positives and resamplings

The Sample Pro Portable 3/4″ MicroPurge Pump uses a quick-change, one-piece bladder design. Compressed gas squeezes the outside of the bladder to force liquid out of the pump; there is no gas contact with the pumped water inside the bladder.Squeeze type bladder pumps are supported by years of independent research that shows they provide unaltered samples for even the most sensitive parameters.

Groundwater enters the pump through the inlet in the upper, head section, then flows down into the bladder. The high inlet helps keep the pump from clogging if it is accidentally lowered into a sediment-filled sump.

Check valves with stainless steel seats and Teflon check balls are located at the inlet and outlet. Inlet screens are replaceable to help ensure proper sealing of the check valves in wells with high solids levels. The SamplePro 3/4″ Pump is shipped in a heavy-duty tube with rubber end caps to help keep the pump clean and protected between uses.

Scroll to Top